GE Multilin PQM User Manual

6–2 PQM POWER QUALITY METER – INSTRUCTION MANUAL
INTRODUCTION CHAPTER 6: SOFTWARE
6.1.2 Hardware
Configuration
The PQM communication can be set up two ways. The figure below shows the connection
using the RS232 front port. FIGURE 6–2: EnerVista PQM Setup Communications Using Rear
RS485 PORT shows the connection through the RS485 port. If the RS232 option is installed,
this port will be visible on the front panel.
FIGURE 6–1: EnerVista PQM Setup Communications Using the Front RS232 Port
PQM Windows Application - PQM
File
Setpoints
Actual
Communication
Help
CHANAGBLE PARAMTERS
X Range:
Sample Rate:
Selection:
Trending Chart
Amps
300.0
250.0
200.0
0-10s
1s
Ib
Actual - Chart Recorder
OK
Cancel
RUN
PRINT
For Help, press F1
PQM RELAY
COMPUTER
RS232 CONNECTOR
TO COMPUTER COM
PORT TYPICALLY
COM1 OR COM2
50.0
-100.0
-80.0
Seconds (Elapsed Time)
-60.0
0
100.0
150.0
-40.0
-20.0
0
STATUS COMMUNICATE RELAYS
VALUE
MESSAGE
ACTUAL
SETPOINT
RESET
STORE
SIMULATION
ALARM
SELF TEST
PROGRAM
TX2
TX1
RX2
RX1
AUX2
ALARM
AUX3
AUX1
823806A3.CDR
RS232
PQM Power Quality Meter
Courtesy of NationalSwitchgear.com

GE Multilin PQM Specifications

General

Brand	GE
Model	Multilin PQM
Category	Measuring Instruments
Language	English