To Next Page

To Previous Page

ADV200 • Functions description and parameters list 5

A – Programming

A.1 Menu display modes

The programming menu can be displayed in two modes, which can be selected using the Access mode pa-

rameter (04 - DRIVE CONFIG menu):

• Easy (default) only the main parameters are displayed.

• Expert all the parameters are displayed

A.2 Programming of “function block” analog and digital input signals

The signals, variables and parameters of each single “function block” of the drive are interconnected in order to

achieve the congurations and controls inside the control system.

These can be managed and modied using the keypad, PC congurator or eldbus programming.

The programming mode is based on the following logic:

Src (source; i.e.: Ramp ref 1 src, PAR: 610)

This term denes the source of the function block input, i.e. the signal to be processed in the

function block.

The different congurations are dened in the relative selection lists

cfg (conguration; i.e.: Mpot init cfg, PAR: 880)

This term refers to the parameter setting and its effect on the function block.

For example: Ramp times, internal reference adjustment, etc...

mon (display; i.e.: Ramp ref 1 mon, PAR: 620)

This term refers to the variable output from the function block, which is the result of the

calculations performed on the actual block

Input selected

Parameter

Variable

Cfg

src Monitor

Function block

A.3 Variable interconnections mode

The source (src) allows the desired control signal to be assigned to the function block input.

This operation is performed by using specic selection lists.

Possible control signal sources:

1 – Physical terminal

The analog and digital signals come from the terminal strip of the regulation card and/or from those of the

expansion cards.

2 – Drive internal variables

Internal drive control system variables, from “function block” calculations, sent via keypad, PC congurator or

eldbus.

gefran ADV200 User Manual

Other manuals for gefran ADV200