To Next Page

To Previous Page

HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Enterprise Fabric Management Suite User Guide 107

Configuring SNMP

The Simple Network Management Protocol configuration includes properties and trap parameters plus

SNMP v3 manager and user parameters.

SNMP configuration and trap configuration parameters

SNMP configuration defines how authentication traps are managed. SNMP trap configuration defines how

traps are set. Choose from the tabs Trap1–Trap 5 to configure each trap.

To configure SNMP for switch or a stack:

1. Select a switch or a stack in the fabric tree.

2. Select Switch > SNMP > SNMP Properties to open the SNMP Properties dialog box (Figure 60). For a

stack, select Stack > SNMP Properties.

3. If you selected a stack, choose a switch from the Initial Configuration drop-down list. Changes that you

make to this switch are distributed to the other switches in the stack.

4. Enter information for the SNMP configuration and SNMP trap configuration fields described in

Table 19.

Authentication Algorithm with which to authenticate the source or destination:

• HMAC-MD5

• HMAC-SHA1

• HMAC-SHA256

• AES-XCBC-MAC

Authentication Key Key string to use for authentication

Encryption Algorithm with which to encrypt outbound data or decrypt inbound data:

• DES-CBC

• 3DES-CBC

• NULL

• BLOWFISH-CBC

• AES-CBC

• TWOFISH-CBC

Encryption Key Key string to use in encrypting or decrypting data

Table 18 Create IP Security Association dialog box fields (continued)

Field Description

HP StorageWorks 8/20q User Manual

Other manuals for HP StorageWorks 8/20q