Operation
224 809480 Instruction Manual XPR300
Make sure that preflow is turned ON during initial height sense (IHS) for all underwater
cutting.
Use the CNC or XPR web interface to activate the IHS. For information
about how to do this, see the instruction manual that came with your
CNC.
Make sure that ohmic contact is disabled for all underwater cutting.
For information about how to disable ohmic contact, see the instruction
manual that came with your CNC.
Underwater cut charts are listed by amperage. They appear with the ferrous and stainless steel cut
charts. Refer to the XPR Cut Charts Instruction Manual (809830).
Underwater cut chart settings are provided for:
Ferrous processes 80 A and above
Non-fuel gas stainless steel processes 80 A and above
Mirror cutting
Consumable parts for mirror cutting are available for all processes. They include a special swirl ring
and shield that causes the gases to swirl in the opposite direction. The opposite-direction gas swirl
makes the “good side” of the cut on the left side, relative to torch motion.
Mirror-cutting consumables are commonly used to cut a “left-handed” version of a “right-handed”
part. Mirror-cutting consumables use the same settings as standard consumables.
For part numbers for mirror-cutting consumables, refer to Example
configurations for consumables on page 138.
To Next Page
Loading...
Need help?
General
