Connect for Communication
XPR300 Instruction Manual 809480 167
Use AP mode to connect
In AP mode, each plasma power supply has its own connection. You can only connect to and
control one plasma power supply at a time. You must have a computer-based device with a screen,
web browser that supports the latest web standards, and wireless access.
1. Supply power to the cutting system:
a. Set the line-disconnect switch to the ON position.
b. Make sure that the power-indicator LED is illuminated on the plasma power supply.
c. Make sure that the remote on-off switch is set to ON.
2. On your device, go to the wireless connections menu.
This menu can be different on different devices.
3. Choose the XPR connection.
The default connection name is “xpr” +
the System ID. The System ID is the
last 4 digits of the Media Access
Control (MAC) address. For more
information on the System ID and MAC
address, refer to Web interface screen
information on page 184.
If you want to change the connection
name, refer to Configure on page 191.
4. Enter the password, “hypertherm”.
If you want to change your password,
refer to Configure on page 191.
5. Open an Internet browser.
To Next Page
Loading...
Need help?
General
