Hypertherm XPR300 User Manual

Diagnostics and Troubleshooting
8
270 809480 Instruction Manual XPR300
507
Failure
Main no CAN There is a problem with the
CAN network when power is
supplied to the cutting
system.
Refer to CAN codes (500 – 503, 510 – 513 for gas
connect console, 504 – 505, 514 – 515 for CAN
cable and jumper block, 507 – 508 for CAN
network and bus, 600 – 602 for no CAN
communication) on page 311.
None Remote on-off
508
Error
CAN Busy The CAN bus is overloaded
(for 10 milliseconds or more).
None Remote on-off
510
Failure
Main->GCC CAN
t/o
The main control PCB cannot
receive communications (at
least once-per-second) from
the gas connect console
(Core, VWI, or OptiMix)
through the CAN.
Refer to CAN codes (500 – 503, 510 – 513 for gas
connect console, 504 – 505, 514 – 515 for CAN
cable and jumper block, 507 – 508 for CAN
network and bus, 600 – 602 for no CAN
communication) on page 311.
Ramp down Remote on-off
511
Failure
Main->Mix CAN t/o The main control PCB cannot
receive communications (at
least once-per-second) from
the gas connect console’s
mix module through the CAN.
Ramp down Remote on-off
513
Failure
Main->TCC CAN
t/o
The main control PCB cannot
receive communications (at
least once-per-second) from
the torch connect console
through the CAN.
Ramp down Remote on-off
514
Failure
Main->Ch1 CAN
t/o
The main control PCB cannot
receive communications (at
least once-per-second) from
Chopper 1 through the CAN.
None Remote on-off
Diagnostic code
number and
category
Diagnostic code
name
Description Corrective action XPR action
Code cancels
with

Hypertherm XPR300 Specifications

General

Brand	Hypertherm
Model	XPR300
Category	Welding System
Language	English