Hypertherm XPR300 User Manual

Wiring Diagrams
10
410 809480 Instruction Manual XPR300
Valve states during operation
During each stage of cutting system operation, different valves are active (ON) or inactive (OFF).
The type of gas connect console and the type and timing of the active process changes the valves
that are active or inactive.
Refer to the CNC or XPR web interface to see the most current information about the
state (ON-OFF) of each valve.
 For information about how to view valve states on the CNC, refer to the instruction manual
that came with your CNC.
 The following steps describe how to view valve states on the XPR web interface:
 Use the XPR web interface to select the process you want to view.
 Go to the Gas System screen. Refer to Gas system on page 186.

On this screen you can see which valves are active when the gas is
flowing. Active valves are indicated with a gray highlight.
 On the Gas System screen, enable the desired mode (Test Preflow, Test Pierceflow, or
Test Cutflow) for the process you want to view.

Active valves are indicated with a gray highlight.
Valve states by process ID
Process IDs: 1001, 1002, 1003, 1152, 1153, 1155, 1004, 1005, 1151, 1156
Block type Gas V1V4V5V6V7V8V9V10V11V12
Preflow
N
2
/Air
Off Off Off On Off Off On Off Off Off
Cutflow
O
2
/Air
On Off Off On Off Off On Off On On
Piercing
O
2
/Air
On Off Off On Off Off On Off Off On
Process IDs: 7001, 7004, 7005, 7007, 7008, 7009, 7010, 7011, 7012, 7013, 7018
Block type Gas V1V4V5V6V7V8V9V10V11V12
Preflow
N
2
/Air
Off Off Off On Off Off On Off Off Off
Cutflow
O
2
/O
2
On Off Off Off On Off On Off On On
Piercing
O
2
/Air
On Off Off On Off Off On Off Off On

Hypertherm XPR300 Specifications

General

Brand	Hypertherm
Model	XPR300
Category	Welding System
Language	English