ITech IT8000 Series Programming Guide

IEEE-488 Common Commands
*ESE <NR1>
Event status enable command. Sets the value in the enable register for the
Standard Event Status group. Each set bit of the register enables a correspond-
ing event. All enabled events are logically ORed into the ESB bit of the status
byte.
• Any or all conditions can be reported to the ESB bit through the enable register.
To set the enable register mask, write a decimal value to the register using
*ESE.
• *CLS does not clear the enable register, but does clear the event register.
Group
None
Syntax
*ESE <NR1>
Arguments
<NR1>
A decimal value corresponding to the binary-weighted sum of the register's bits.
The setting range is from 0 to 255.
Default Value
0
Returns
None
Example
Enable bits 3 and 4 in the enable register: *ESE 24
Also see
*ESE?
Copyright © Itech Electronic Co., Ltd.
164

ITech IT8000 Series Specifications

General

Brand	ITech
Model	IT8000 Series
Category	Test Equipment
Language	English