ITech IT8000 Series Programming Guide

IEEE-488 Common Commands
Group
None
Syntax
*RST
Arguments
None
Default Value
None
Returns
None
Example
*RST
Also see
None
*SRE <NR1>
Service request enable command. This sets the value of the Service Request
Enable register. This determines which bits from the Status Byte Register are
summed to set the Master Status Summary (MSS) bit and the Request for Serv-
ice (RQS) summary bit. A 1 in any Service Request Enable register bit position
enables the corresponding Status Byte register bit. All such enabled bits are
then logically OR-ed to cause the MSS bit of the Status Byte register to be set.
Group
None
Syntax
*SRE <NR1>
Copyright © Itech Electronic Co., Ltd.
171

ITech IT8000 Series Specifications

General

Brand	ITech
Model	IT8000 Series
Category	Test Equipment
Language	English