ITech IT8000 Series Programming Guide

Error Messages
17 Error Messages
If the instrument generates a fault during communication with the host computer
or executes a programming command that is not supported by the instrument,
the word Error will be displayed on the front panel VFD. At the same time, the
user can send the SYSTem:ERRor? command through the host computer, and
the instrument will return the error code and the corresponding error message.
The detailed error code and description information are as follows.
Error
Code
Error Message Description
0
No error
This is the response to the
ERR? query when there are no
errors.
Parameter setting related errors
101 DESIGN ERROR: Too many
numeric suffices in Command
Spec
The number of numeric param-
eters of the command exceeds
the limit.
110 No Input Command to parse No command input (for exam-
ple, the error code is reported
when an empty command is
sent).
114 Numeric suffix is invalid value The number sent to the com-
mand does not match the num-
ber specified in the command
specification.
116 Invalid value in numeric or
channel list, e.g. out of range
The value or list parameter is
invalid, such as out of range.
117 Invalid number of dimensions
in a channel list
Invalid value in parameter list
120 Parameter of type Numeric
Value overflowed its storage
Digital parameter overflow, for
example, the parameter setting
value is not within the settable
range.
130 Wrong units for parameter The unit of the parameter is
incorrect.
Copyright © Itech Electronic Co., Ltd.
180

ITech IT8000 Series Specifications

General

Brand	ITech
Model	IT8000 Series
Category	Test Equipment
Language	English