ITech IT8000 Series Programming Guide

SYSTem Subsystem
• If the instrument is turned off or the *CLS (clear status) command is sent, the
error message in the error queue will be cleared. The *RST command will
not clear the error message in the error queue.
SYSTem:CLEar
This command is used to clear the error queue.
Group
System
Syntax
SYST:CLE
Arguments
None
Default Value
None
Returns
None
Example
SYST:CLE
Also see
None
SYSTem:REMote
This command is used to set the instrument to the remote control mode via the
communication interface. Except the Local key on the front panel, other keys
are locked and cannot be used.
Copyright © Itech Electronic Co., Ltd.
15

ITech IT8000 Series Specifications

General

Brand	ITech
Model	IT8000 Series
Category	Test Equipment
Language	English