ITech IT8000 Series Programming Guide

CONFigurable Subsystem
[CONFigurable:]IO:SELect?
This command is used to query the pin number of the digital I/O interface. Pins
1 to 7 correspond to number 0 to 6.
Group
CONFigurable
Syntax
[CONFigurable:]IO:SELect?
Arguments
None
Default Value
None
Returns
<NR1>
The range is from 0 to 6.
Example
IO:SEL?
Also see
None
[CONFigurable:]IO:DIRection <NRL>, <Bool>
This command is used to set the direction of the digital signal of the specified
pin:
• <NRL>: Used to specify the pin number. Pins 1 to 7 correspond to number 0
to 6.
• <Bool>: Used to specify the direction of the digital I/O signal.
– 0|OUT: The digital I/O signal is sent out from the pin of this instrument.
Copyright © Itech Electronic Co., Ltd.
41

ITech IT8000 Series Specifications

General

Brand	ITech
Model	IT8000 Series
Category	Test Equipment
Language	English