Industrial Sewing Machine SADE
18
To use the machine with safety, be sure to use it under the environment which sat-
isfies the following conditions:
Ambient temperature during operation 5°C to 35°C
Relative humidity during operation 35 % to 85 %
Dew condensation can occur if bringing the machine suddenly from a cold envi-
ronment to a warm one. So, be sure to turn the power on after having waited for a
sufficient period of time until there is no sign of water droplet in order to prevent
accident caused by breakage or malfunction of the electrical components.
Be sure to stop operation when lightning flashes for the sake of safety and remove
the power plug in order to prevent accident caused by breakage or malfunction of
the electrical components.
In order to ensure the work environment, local laws and regulations in the country
where the sewing machine is installed shall be followed. In the case the noise con-
trol is necessary, an ear protector or other protective gear should be worn accord-
ing to the applicable laws and regulations.
Disposal of products and packages and treatment of used lubricating oil should be
carried out properly according to the relevant laws of the country in which the sew-
ing machine is used.
2.6 Items for which the power to the machine has to be turned off
Turn the machine off by switching the main switch at the control box to „0”, then secure
it in position "0".
Switch off the sewing control motor before threading up, cleaning and first line
maintenance. Wear eye protection during the sewing.
Switch off the sewing control motor and log-off from Sade before you leave the
machine. This will prevent unauthorized production and accidents.
Be sure to immediately turn the power off if any abnormality or failure is found or in
the case of power failure in order to protect against accident that can result in per-
sonal injury or death.
To protect against accident resulting from abrupt start of the machine, be sure to
carry out the following operations after turning the power off. For the machine in-
corporating a clutch motor, in particular, be sure to carry out the following opera-
tions after turning the power off and verifying that the machine stops completely.
o For example, threading the parts such as the needle, looper, spreader etc.
which have to be threaded, or changing the bobbin.
o For example, changing or adjusting all component parts of the machine.
o For example, when inspecting, repairing or cleaning the machine or leaving
the machine.
Be sure to remove the power plug by holding the plug section instead of the cord
section in order to prevent electrical-shock, earth-leakage or fire accident.
Be sure to turn the power off whenever the machine is left unattended between
works.
To Next Page
Loading...
Need help?
General
