Industrial Sewing Machine SADE
90
Label post seam settings:
You select the label, then you select the scanning operation, you select the sewing if it
should be done within the post seam or maybe at a different position. Message.
Fig. 61. Post seam label
7.1.2.16 Message – Post check
This checkbox and free text entry enables the possibility to interact with the operator
and to make this interaction part of the product evaluation. For example: When the op-
erator arrives at the second notch, a message pops up. The operator is asked to per-
form some kind of visual inspection of the product. At the same time response of the
operator is required. The message might look like: Do you see more than 3 loops in the
tear seam area?
Fig. 62. Message – Post check
7.1.2.17 Label position end of automatic mode
After the last notch, once the set-point is reached, the machine will move into manual
mode until the next scan of parts have been performed. The operator will have to re-
lease the pedal before sewing can continue. This feature is primarily used to increase
awareness of the importance of the product traceability label and give the handling of
the label a fixed place in the production cycle. If scan-back is used, a message will ap-
pear where the operator is forced to present the barcode to a scanner in order to con-
To Next Page
Loading...
Need help?
General
