KEB COMBIVERT F5 Servo User Manual

6
917
KEB COMBIVERT F5
Name: Basis
04.05.04
6
Section PageDate
© KEB Antriebstechnik, 2002
All rights reserved
Chapter
Functional DescriptionSpecial Functions
Param. Adr.
min
max
default
ENTER
PROG.
RO
Step
At using the brake control the direction of rotation (oP.1) may not be set to „7“, because
then no Low-Speed-Signal (LS) is output.
Used Parameters
Pn.34 0422h - ✔✔ 0410-
Pn.35 0423h - ✔ - 0,00 s 100,00 s 0,01 s 0,25 s -
Pn.36 0424h - ✔ - 0,00 s 100,00 s 0,01 s 0,25 s -
Pn.37 0425h - ✔ - -20 Hz 20 Hz 0,0125 Hz 0 Hz F5-G/B depending on ud.2
0425h - ✔ - -600 rpm 600 rpm 0,125 rpm 0 Hz F5-M/S depending on ud.2
Pn.39 0427h - ✔ - 0,00 s 100,00 s 0,01 s 0,25 s -
Pn.40 0428h - ✔ - 0,00 s 100,00 s 0,01 s 0,25 s -
Pn.41 0429h - ✔ - -20 Hz 20 Hz 0,0125 Hz 0 Hz F5-G/B depending on ud.2
0429h - ✔ - -600 rpm 600 rpm 0,125 rpm 0 Hz F5-M/S depending on ud.2
Pn.43 042Bh - ✔ - 0 100 % 1 % 0 % -
Start value (Pn.37)
Stop value (Pn.41)
The adjustable start/stop value stands in direct connection with the necessary holding
torque. The preadjustment, according to following formula, is valid for rated motor
torques:
(no-load motor speed - rated motor speed) x rated motor frequency
Start-/Stop value=
no-load motor speed
(1500rpm
- 1420rpm ) x 50Hz
Example: = 2,67 Hz
1500rpm
The direction into which the holding torque shall take effect is determined by the sign.
The parameters are set-programmable.

KEB COMBIVERT F5 Servo Specifications

General

Brand	KEB
Model	COMBIVERT F5 Servo
Category	DC Drives
Language	English