Keithley 6220 User Manual

Model 6220/6221 Reference Manual Triggering 8-7
Return to Section 8 topics
Output triggers
The Model 622x can send out an output trigger (via the rear panel TRIGGER LINK
connector) right after the source and delay phase of the device action and/or when
operation enters or exits the trigger layer. An output trigger can be used to trigger
another instrument to perform an operation (e.g., select the next scanner channel).
See “External triggering,” on page 8-13 for details on using external triggering.
Front panel trigger operation
Using the trigger configuration menu
To configure trigger functions, press CONFIG then TRIG, then make your selec-
tions from Table 8-1 below. See the detailed procedures for setting up triggering
on page 8-8.
Table 8-1
Trigger configuration menu
Menu selection Description
ARM-LAYER
ARM-IN
TIMER
TLINK
EVENT DETECT BYPASS
ARM-OUT
LINE
EVENTS
TRIG-LAYER-EXIT
TL-ENTER
Configure arm layer:
Set arm-in events: IMMEDIATE, GPIB, TIMER, MANUAL, TLINK,
⇓STEST, ⇑STEST, ⇓⇑STEST.
Set timer INVERVL: 0 to 99999.999s.
Set trigger link line (1 to 6).
Select ONCE or NEVER.
Set arm out line and events:
Set trigger out line (1 to 6).
Select arm out events.
Select ON or OFF.
Select ON or OFF.
TRIG-LAYER
TRIGGER-IN
IMMEDIATE
TRIGGER-LINK
EVENT DETECT BYPASS
TRIGGER-OUT
LINE
EVENTS
SOURCE
DELAY
Configure trigger layer:
Set trigger in events:
Immediate trigger.
Select trigger link and line (1 to 6).
Set event bypass (ONCE or NEVER)
Set trigger out events:
Set trigger out line (1 to 6).
Set trigger output events.
Select ON or OFF.
Select ON or OFF.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com

Keithley 6220 Specifications

General

Brand	Keithley
Model	6220
Category	Measuring Instruments
Language	English