Model 6220/6221 Reference Manual DC Current Source Operation 3-9
Return to Section 3 topics
Setting source and compliance
Source and compliance editing from the front panel cannot be performed from the
front panel if the Model 622x is in remote. To return to the local state, press the
LOCAL key.
For remote programming, commands to select source range and set source and
compliance values are documented in Table 3 -2 . Programming examples are also
provided in the procedure for “Sourcing current,” on page 3-14.
Source and compliance editing
Figure 3-3 shows how to set source and compliance values for the Model 6220.
Figure 3-4 shows the source and compliance editing controls for the Model 6221. The
procedure to set source and compliance values for the Model 6221 follow Figure 3-4.
“Source/compliance editing notes” for both procedures are provided on page 3-11.
NOTE After calculating settling time (ST), compare it to
the published settling time specification in
Appendix A. The larger of the two settling times
will apply.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
