Model 6220/6221 Reference Manual Getting Started 1-11
Return to Section 1 topics
Figure 1-2
Model 622x rear panel
1 IEEE-488
Connector for IEEE-488 (GPIB) operation. Use a shielded cable, such as the Model 7006,
7007, or 7008.
2 OUTPUT
3-lug female triax connector for current source output. Mates to the supplied triax cable
(237-ALG-2). Will also mate to any triax cable terminated with a 3-slot male triax connector.
3 ETHERNET (6221 only)
RJ45 female connector for Ethernet operation. Use an RJ45 male/male cable for connec-
tion. Two status LEDs are located at the top of the connector. These LEDs indicate status
of the Ethernet (see Section 10 for details).
4 DIGITAL I/O
Male DB-9 connector. Four pins for digital output, one pin for Start of Test (SOT) trigger,
and one for external voltage (VEXT) input.
5 RS-232
Female DB-9 connector:
• For RS-232 operation, use a straight-through (not null modem) DB-9 shielded cable
for connection to the PC.
• For Delta, Pulse Delta, and Differential Conductance, use the supplied serial cable
(CA-351) for connections between the Model 622x and the Model 2182/2182A
.
The rear panels of the Model 6220 and 6221 are the same, except the
Model 6220 does not have an Ethernet connector (3).
MADE IN
U.S.A.
INTERNALLY
SWITCHED
1 AMP MAX.
HI
CABLE
GUARD
105Vpk
LO
105Vpk
250Vpk
OUTPUT
CAT I
IEEE-488
(CHANGE IEEE ADDRESS
WITH FRONT PANEL MENU)
ETHERNET
10/100 BaseT
10bT 100bT
DIGITAL I/O
RS-232
TRIGGER
LINK
LINE FUSE
SLOWBLOW
1.6A, 250V
LINE RATING
100-240VAC
50, 60Hz
120VA MAX.
250Vpk
105Vpk
LO
GUARD
INTERLOCK
!
!
1 234567 89
6221 only
NOTE
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
