1-16 Getting Started Model 6220/6221 Reference Manual
Return to Section 1 topics
• The instrument model number, firmware revision levels, and the GPIB
address are displayed briefly as follows:
MODEL 622x
Rev: xxx yyyy SCPI: 24
where: xxx is the main board ROM revision.
yyyy is the display board ROM revision.
• For the Model 6221, the messages “LOADING WAVEFORM...” and then
“WAVEFORM LOAD DONE” are displayed briefly.
System identification
Serial numbers and revisions (for the mainframe, analog board, digital board, and
SCPI) can be displayed by selecting the SERIAL# item of the main menu (press
MAIN > Select SERIAL#).
For remote programming, use the following commands to read serial numbers
(SN) and revisions.
Beeper and keyclick
Beeper
With the beeper enabled, a beep will be issued to acknowledge the following
actions:
• A short beep is issued when a front panel key is pressed.
• For the Model 6221, a short beep is also issued when the rotary knob is
turned or pressed.
• When an error occurs, a slightly longer beep is issued.
• A longer beep is issued when a setup is saved from the front panel.
NOTE There are two internal LEDs that turn on and blink for a few
seconds during the power-up sequence. One LED is visible
through the top cover air vents, and the other LED is visible
through the air vents on the right side of the case. After the
short period of blinking, these LEDs will remain off while the
instrument is on.
*IDN? ‘
‘
Returns serial number revision level of the main-
frame.
SYSTem:ABOard:SNUMber? ‘ Returns SN for the analog board.
SYSTem:ABOard:REVision? ‘ Returns revision of the analog board.
SYSTem:DBOard:SNUMber? ‘ Returns SN for the digital board.
SYSTem:DBOard:REVision? ‘ Returns revision of the digital board.
SYSTem:VERSion? ‘ Returns version of SCPI standard (e.g., 1999.0).
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
