14-14 SCPI Reference Tables Model 6220/6221 Reference Manual
Return to Section 14 topics
Table 14-8
System command summary
Command Description Default Sec SCPI
:SYSTem 5
:COMMunicate Communication interfaces: 10
:SELect <name> Select interface: SERial, GPIB or ETHernet.
:GPIB GPIB interface:
:ADDRess <NRf> Set primary address: 0 to 30.
:ADDRess? Query primary address.
:SERial RS-232 interface:
:CONTrol Handshaking:
:RTS <name> Select handshaking: IBFull, RFR, or OFF.
:RTS? Query handshaking.
:PACE <name> Set flow control: XON or OFF
:PACE? Query flow control.
:TERMinator <name> Set output terminator: CR, LF, CRLF, or
LFCR.
:TERMinator? Query output terminator.
:BAUD <n> Set baud rate: 300, 600, 1200, 2400, 4800,
9600, 19.2k, 38.4k, 57.6k, or 115.2k.
:BAUD? Query baud rate.
:SEND <data> Send data via RS-232.
:ENTer? Reads data from serial port.
:LOCal RS-232 only – Take 622x out of remote.
:REMote RS-232 only – Put 622x in remote.
:RWLock <b> RS-232 only – Enable or disable local lockout.
:RWLock? RS-232 only – Query state of local lockout.
:ETHernet Ethernet interface (6221 only):
:ADDRess <string> Set IP address: “n.n.n.n”.
:ADDRess? Query IP address.
:MASK <string> Set subnet mask: “n.n.n.n”.
:MASK? Query subnet mask.
:GATeway <string> Set Ethernet gateway: ”n.n.n.n”.
:GATeway? Query Ethernet gateway.
:DHCP <b> Enable or disable DHCP.
:DHCP? Query state (on or off) of DHCP.
:SAVE Saves Ethernet setting changes.
:KEY <n> Simulate key press.
See “SYSTem key-press codes,” on page 13-9.
13
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
