Keithley 7001 User Manual

IEEE-488 Reference
5-121
5.18 Trigger subsystem
The Trigger Subsystem is made up of a series of commands and subsystems to configure the three layers of the Trigger Model
(see Figure 5-13). These commands and subsystems are summarized in Table 5-13.
Table 5-13
Trigger command summary
Command Description Reference
:INITiate
[:IMMediate]
:CONTinuous <b>
:CONTinuous?
:ABORt
:ARM[:SEQuence[1]]
[:LAYer[1]]
:IMMediate
:COUNt <n>
:COUNt?
:SOURce <name>
:SOURce?
:SIGNal
:TCONfigure
:DIRection <name>
:DIRection?
:ASYNchronous
:ILINe <NRf>
:ILINe?
:OLINe <NRf>
:OLINe?
:LAYer2
:IMMediate
:COUNt <n>
:COUNt?
:DELay <n>
:DELay?
:SOURce <name>
:SOURce?
:TIMer <n>
:TIMer?
:SIGNal
Subsystem command path:
Initiate one trigger cycle.
Enable (1 or ON) or disable (0 or OFF) continuous initiation of
trigger system.
Query continuous initiation.
Reset trigger system.
Subsystem command path to configure arm layers:
Path to program arm layer 1:
Immediatey go to Layer2.
Program arm count (1 to 9999, or INF).
Query arm count.
Select control source: HOLD, IMMediate, MANual, BUS,
TLINk, EXTernal.
Query control source.
Loop around control source.
Path to configure Triggers:
Enable (SOURce) or disable (ACCeptor) Bypass:
Query direction.
Path to configure asynchronous Trigger Link:
Select input line (1 to 6).
Query input line.
Select output line (1 to 6).
Query output line.
Path to program arm layer 2:
Immediately go to Trigger Layer.
Program scan count (1 to 9999 or INF).
Query scan count.
Program delay (0 to 99999.999 sec)
Query delay.
Select control source: HOLD, IMMediate, TIMer,
MANual, BUS, TLINk, EXTernal.
Query control source.
Set timer interval (0 to 99999.999 sec).
Query timer.
Loop around control source.
5.18.1
5.18.2
5.18.3
5.18.4
5.18.6
5.18.8
5.18.9
5.18.3
5.18.4
5.18.5
5.18.6
5.18.7
5.18.8
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com

Keithley 7001 Specifications

General

Brand	Keithley
Model	7001
Category	Switch
Language	English