EasyManuals Logo

Komatsu PC16R-3 User Manual

Komatsu PC16R-3
288 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #180 background imageLoading...
Page #180 background image
LONG PERIODS OF INACTIVITY
178
3.6 LONG PERIODS OF INACTIVITY
3.6.1 BEFORE A PERIOD OF INACTIVITY
IMPORTANT
q
To protect the hydraulic cylinder rods while the machine is
not used, position the work equipment as shown in the
figure on the right.
(This prevents the cylinder rods from rusting).
q
Before removing the battery, stop the engine, wait at least
one minute, and afterwards turn the battery main switch to
OFF and extract the specific key.
If the machine is going to remain unused for a long period (more
than one month), proceed as indicated below.
q
Clean and wash all the machine components, then store the
machine indoors. If the machine is going to be stored outdoors,
choose a level surface and cover the machine with a cloth.
q
Fill the fuel tank completely, to prevent the accumulation of con-
densate.
q
Lubricate where necessary and change the oil.
q
Coat the exposed portion of the hydraulic cylinder piston rod with grease.
q
After shutting off the engine, wait over one minute, then turn the battery disconnect switch to the OFF position
and take out the battery disconnect switch key. Put a cover on the battery during storage.
q
Lock all the control levers and pedals with the safety lever and the pedal locking device.
q
If the machine is equipped with attachments, shift the selection lever to position “Breaker or other attachments“.
3.6.2 DURING A PERIOD OF INACTIVITY
WARNING
q
If it is necessary to carry out a rust-prevention treatment while the machine is kept indoors, open doors
and windows to increase ventilation and avoid poisoning by gas.
When the machine is not used, start the machine once a month following the steps below.
q
Recharge the battery and install it on the machine.
q
Insert the key into the battery main switch and turn it to ON.
q
Start the engine and make some movements with the working tools so as to cover the moving parts and all the
component surfaces with a new oil layer.
q
When operating the work equipment, remove all the grease from the hydraulic cylinder rods.
WEAM012405

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Komatsu PC16R-3 and is the answer not in the manual?

Komatsu PC16R-3 Specifications

General IconGeneral
BrandKomatsu
ModelPC16R-3
CategoryExcavators
LanguageEnglish

Related product manuals