Konica Minolta bizhub C364 User Manual

17
17-18 bizhub C554/C454/C364/C284/C224
[Center Staple Position]
To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Finisher Adjustment]
- [Center Staple Position]
If the staple position is not on the fold line on saddle-stitched paper, use this option to align the staple posi-
tion on the fold.
Copy after configuration, then repeat adjustments as required.
Tips
- This item is available when the Finisher FS-534 and Saddle Stitcher SD-511 are installed.
- This item is available when the Finisher FS-535 and Saddle Stitcher SD-512 are installed (only for
bizhub C554).
- Adjust the half-fold position before adjusting the center staple position.
- Make adjustment while checking paper stapled at a displaced position.
- The value you set by selecting [All] in [Paper Size] will be added to the setting for each paper size.
- For adjustments to put staples parallel with the left edge of paper, contact your service representative
for instructions.
[Horizontal Punch (Z-Fold)
Position Adjustment]
If the positions of the punch holes on the paper are displaced sideways,
use this option to adjust the punch hole positions.
For details, refer to page 17-24.
[1st Z-Fold Position Adjust-
ment]
Use this option to adjust the 1st Z-fold position.
For details, refer to page 17-25.
[2nd Z-Fold Position Ad-
justment]
Use this option to adjust the 2nd Z-fold position.
For details, refer to page 17-25.
[Punch Unit Size Detect
Sensor]
Use this option to adjust the sensor of the Punch function to detect the
edge of the paper.
For details, refer to page 17-26.
[Post Inserter Tray Size Ad-
justment]
If the size of the paper loaded into the post inserter is not detected correct-
ly, use this option to automatically adjust it so that it is detected correctly.
For details, refer to page 17-26.
[Paper Alignment Plate
Settings]
If paper is not discharged with the edges aligned, use this option to adjust
the effective width of the paper alignment plate for making discharged pa-
per stored neatly.
For details, refer to page 17-26.
Settings Description
Settings Description
[Paper Size] Select the size of paper that is used to adjust the staple position.
[Adjust Value] Enter an adjustment value between -10.0 mm and 10.0 mm by tapping [-]
and [+].
• [-]: Move the staple position to the left.
• [+]: Move the staple position to the right.
[0.0 mm] is specified by default.

Konica Minolta bizhub C364 Specifications

General

Category	All in One Printer
Functions	Print, Copy, Scan, Fax
Printing Technology	Laser
Print Speed	36 ppm
Print Resolution	1200 x 1200 dpi
Max Resolution (BW)	1200 x 1200 dpi
Max Resolution (Color)	1200 x 1200 dpi
Duplex Printing	Yes
Max Paper Capacity	3, 650 sheets
Scan Resolution	600 x 600 dpi
Copy Resolution	600 x 600 dpi
Reduction/Enlargement	25% - 400%
Dimensions	615 x 685 x 779 mm
Supported Paper Sizes	A6
Copy Speed	36 cpm
Interface	USB 2.0, Ethernet
Standard Paper Capacity	1, 150 sheets