bizhub C554/C454/C364/C284/C224 17-25
17
- Make adjustments while checking paper punched at a displaced position.
[1st Z-Fold Position Adjustment]
To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Finisher Adjustment]
- [1st Z-Fold Position Adjustment]
Use this option to adjust the 1st Z-fold position.
Copy after configuration, then repeat adjustments as required.
Tips
- This adjustment is possible when the Finisher FS-535 and Z Folding Unit ZU-606 are installed in
bizhub C554.
- Make adjustment while checking paper folded at a displaced position.
- The value you set by selecting [All] in [Paper Size] will be added to the setting for each paper size.
[2nd Z-Fold Position Adjustment]
To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Finisher Adjustment]
- [2nd Z-Fold Position Adjustment]
Use this option to adjust the 2nd Z-fold position.
Copy after configuration, then repeat adjustments as required.
Settings Description
[Paper Size] Select the size of paper that is used to adjust the fold position.
[Adjust Value] Enter an adjustment value between -12.8 mm and 12.7 mm by tapping [-]
and [+].
• [-]: Move the punch position to the right.
• [+]: Move the punch position to the left.
[0.0 mm] is specified by default.
Settings Description
[Paper Size] Select the size of paper that is used to adjust the fold position.
[Adjust Value] Enter an adjustment value between -12.8 mm and 12.7 mm by tapping [-]
and [+].
• [-]: Move the punch position to the right.
• [+]: Move the punch position to the left.
[0.0 mm] is specified by default.
To Next Page
Loading...
Need help?
General
