bizhub C554/C454/C364/C284/C224 17-27
17
[Density Adjustment]
To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Density Adjustment]
Adjust the density of images that are printed on thick paper, OHP transparencies, or envelops for each paper
type and print color.
To adjust the density of an image that is printed in black and white, select [Black Image Density].
The larger the number, the darker the background.
[0] is specified by default.
[Image Stabilization]
To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Image Stabilization]
Correct the misalignment or tilt of scanning area caused by changes in the temperature or humidity in the
machine to ensure high quality printing.
[Paper Separation Adjustment]
To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Paper Separation
Adjustment]
Adjust the paper separation position on each side of paper for 2-sided printing.
Adjust balance between the properties related to paper separation and image transfer when paper jams are
occurring or images are defective due to the environment being overly hot or humid.
Settings Description
[Image Stabilization Only] Adjusts the displacement or inclination of the scanning section. Select a
method for image stabilization and then press Start to execute image sta-
bilization.
• [Image Stabilization Only]: Executes the standard image stabilization
process.
• [Initialize + Image Stabilization]: Initializes the log information on image
stabilization control and then executes image stabilization. Select this
option when [Image Stabilization Only] has failed to work.
[Image Stabilization Only] is specified by default.
[Image Stabilization Set-
ting]
Change the timing for executing image stabilization as well as the type of
image stabilization, as required. Make selection according to the printing
frequency and the color/black use ratio.
• [Standard]: Select this option when the printing frequency is low and
the color printing ratio is high. Normal image stabilization is performed
if a change in the absolute humidity is detected during warm-up.
• [Color Priority]: Select this option when both the printing frequency and
the color printing ratio are high. Color image stabilization is performed
if a change in absolute humidity is detected during warm-up.
• [Black & White Priority]: Select this option when both the printing fre-
quency and the color printing ratio are low. Monochrome image stabi-
lization is performed if a change in absolute humidity is detected during
warm-up. Color image stabilization is to be performed before printing
color documents.
[Standard] is specified by default.
Settings Description
[Front (Except Thin Pa-
per)]/[Back (Except Thin
Paper)]/[Front (Thin Pa-
per)]/[Back (Thin Paper)]
Select the paper and side on which to adjust the paper separation.
[Adjust Value] Enter an adjustment value between -10.0 mm and 10.0 mm by tapping [-]
and [+].
Increase the value if paper jams are occurring, and decrease it if the image
is transferred unevenly.
[0.0 mm] is specified by default.
To Next Page
Loading...
Need help?
General
