8
Using the Scan Functions
8-46 C350
8.8 Performing Scan to FTP Server Operations
The Scan to FTP Server operation is used to send the image data
scanned on this machine to an FTP server.
✎
Note
To perform Scan to FTP Server operations, a network environment
with an FTP server is required.
8.8.1 Flow of Scan Operation
Procedure
1 Using PageScope Web Connection, register FTP servers (up to five).
☞ “Registering FTP Servers” on page 8-48
2 If “Use Proxy” was set to “Yes” on the FTP Server Registration page,
set the proxy server.
☞ “Setting the Proxy Server” on page 8-51
3 Using PageScope Web Connection, perform one-touch key
registration or temporary key registration.
☞ “Registering Destinations in Advance” on page 8-25
4 Using this machine’s control panel, specify the destination of the
scanned data.
☞ “Setting the Destination” on page 8-52
5 Using this machine’s control panel, set the scan mode and document
designation.
☞ “Scan Mode Screen” on page 8-14 and “Original Setting Screen” on
page 8-16
6 Set the document, and then press the [Start] key on this machine’s
control panel.
The document is scanned. The scanned data is sent to the FTP
server.
If a URL notification destination was specified, information indicating
the storage location of the scanned data is sent by e-mail.
To Next Page
Loading...
Need help?
General
