BRAKES 106
Info
Pull the brake lever forward and turn the adjusting screw.
Turn the adjusting screw clockwise to increase the distance between the hand
brake lever and the handlebar.
Turn the adjusting screw counterclockwise to decrease the distance between the
hand brake lever and the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
Do not make any adjustments while riding!
11.3Checking brake discs
Warning
Danger of accidents Reduced braking efficiency due to worn brake disc(s).
– Change the worn brake disc(s) without delay. (Your authorized KTM workshop will be glad to help.)
400362-10
– Check the thickness of the front and rear brake discs at several places on the disc to
see if it conforms to measurement A.
Info
Wear reduces the thickness of the brake disc around the area used by the brake
linings.
Brake discs - wear limit
Front 3.5 mm (0.138 in)
Rear 3.5 mm (0.138 in)
» If the brake disc thickness is less than the specified value:
To Next Page
Loading...
Need help?
General
