Lantronix SLC 8000 Series User Manual

15: Command Reference
SLC™ 8000 Advanced Console Manager User Guide 372
Description
Runs an iPerf server or client to measure network throughput. You can optionally email the output.
The SLC uses iPerf version 3.X, which is incompatible with older versions (2.x).
diag lookup
Syntax
diag lookup <Name> [email <Email Address>]
Description
Resolves a host name into an IP address. You can optionally email the displayed information.
diag loopback
Syntax
diag loopback <Device Port Number or Name>[<parameters>]
Parameters
test <internal|external>
xferdatasize <Size In Kbytes to Transfer>
Defaults: test=external, xferdatasize=1K
Description
Tests a device port by transmitting data out the port and verifying that it is received correctly.
A special loopback cable comes with the SLC 8000 advanced console manager. To test a device
port, plug the cable into the device port and run this command. The command sends the specified
Kbytes to the device port and reports success or failure. The test is performed at 9600 baud. Only
an external test requires a loopback cable. The External test is currently not supported for USB
device ports.
diag netstat
Syntax
diag netstat [protocol <all|tcp|udp>] [email <Email Address>]
Defaults: protocol=all
Description
To display a report of network connections. You can optionally email the displayed information.

Lantronix SLC 8000 Series Specifications

General

Brand	Lantronix
Model	SLC 8000 Series
Category	Switch
Language	English