Error
code
Description Action
407.23 Paper going to bin 2 did not reach the
sensor (OE pass‑through) on time.
See
“Sensor (OE pass‑through) late-arriving jam service
check” on page 189.
407.25 Paper going to bin 2 did not clear the
sensor (OE pass‑through) on time.
See
“Sensor (OE pass‑through) late-leaving jam service
check” on page 191.
407.33 Paper going to bin 3 did not reach the
sensor (OE pass‑through) on time.
See
“Sensor (OE pass‑through) late-arriving jam service
check” on page 189.
407.35 Paper going to bin 3 did not clear the
sensor (OE pass‑through) on time.
See
“Sensor (OE pass‑through) late-leaving jam service
check” on page 191.
407.43 Paper going to bin 4 did not reach the
sensor (OE pass‑through) on time.
See
“Sensor (OE pass‑through) late-arriving jam service
check” on page 189.
407.45 Paper going to bin 4 did not clear the
sensor (OE pass‑through) on time.
See
“Sensor (OE pass‑through) late-leaving jam service
check” on page 191.
Output expander diverter drive jam service check
Action Yes No
Step 1
Make sure that all the optional bins are properly installed.
Does the problem remain?
Go to step 2. The problem is
solved.
Step 2
Open all optional bin doors, and then check the paper path and
bins for paper fragments and partially fed paper.
Is the paper path free of paper fragments and partially fed paper?
Go to step 4. Go to step 3.
Step 3
Remove the paper fragments and partially fed paper.
Does the problem remain?
Go to step 4. The problem is
solved.
Step 4
Clear the optional bin paper path rollers of any dirt and
contamination.
Does the problem remain?
Go to step 5. The problem is
solved.
Step 5
a Enter the Diagnostics menu, and then navigate to:
Output bin quick feed > Feed to all bins
b To uc h Single or Continuous.
Does the problem remain?
Go to step 6. The problem is
solved.
4064
Diagnostics and troubleshooting
187