UMX-TPS-TX100 series – User's Manual 113
Change the Autoselect Mode
Command and Response #audio
ç <out>:<out_set>)
æ
Parameters
See at previous section.
Example 1
ç
æ
The setting is changed to EPM: Autoselect is enabled (E); the mode is set to Priority detect (P), and the port will
be disconnected if a higher priority port becomes active (M).
Example 2
ç
æ
The setting is changed to DPM Autoselect is disabled (D). The other settings remain unchanged. Since the
outputs are linked, the change will affect local and link out.
INFO: For more information about the Autoselect feature see The Autoselect Feature section.
Command and Response
ç
æ
<out1_list>;<out2_list>;<…>;<out#_list>
The response shows the priority of each output one after another. The priority number can be from 0 to 31;
0 is the highest- and 30 is the lowest priority. 31 means that the port will be skipped from the priority list.
Parameters
<out1_list> The input port priority order of the given output port: <in1>,<in2>,…,<in>
Example
ç
æ
Output
I1 I2 I3 I4 I5
Priority 0 1 2 3 4 5
Highest priority is assigned to I1 port.
ATTENTION!
match, the input port with the lowest port number will have the highest priority.
Change the Input Port Priority
Command and Response #audio
ç
<(in>
\(<out>
\):<prio>
);(<in>
\(<out>
\):<prio>
) æ
Parameters
<prio> Priority number from 0 to 31, equal numbers are allowed (31 means that the port will be
skipped from the priority list).
An input port priority can be set on an output port. Many settings can be executed by separating a semicolon
(no space), see the example below.
Example
ç
æ
The priority number of input 1 and Input 2 has been set to 4 on output 1. The example shows that certain
See more information about the escaping in the Escaping section.
To Next Page
Loading...
Need help?
General
