UMX-TPS-TX100 series – User's Manual 51
Install and Update
INFO:
version with the same attributes.
Minimum System Requirement
RAM: 1 GB
Minimum display resolution
Installation for Windows OS
Run the installer. If the User Account Control drops a pop-up message click Yes.
During the installation you will be prompted to select the type of the installation: normal and the snapshot
install:
Normal install Snapshot install
The installer can update only this instance Cannot be updated
Only one updateable instance can exist for all users More than one different version can be installed for all users
Comparison of installation types
ATTENTION! Using the Normal install as the default choice is highly recommended.
Installation for macOS
over the desired folder.
ATTENTION!
exceptions of the blocked software for the proper operation.
Updating of LDC
Step 1. Run the application.
The Device Discovery window appears automatically and the program checks the available updates on
The current and the update version number can be seen at the top of the window and they are shown in this
window even with the snapshot install.
The Update window can also be opened by clicking the About icon and the Update button.
Step 2. Set the desired update setting in the Options section.
▪ If you do not want to check for the updates automatically, uncheck the circle, which contains the green
tick.
▪ If you want to postpone the update, a reminder can be set with different delays from the drop down list.
▪ If the proxy settings traverse the update process, set the proper values then click the OK button.
Step 3. Click the Download update button to start the updating.
The updates can be checked manually by clicking the Check now button.
Running the LDC
The common way to start the software is double-click on
parameters as follows:
Connecting to a Device with Static IP Address
static IP address directly; the Device Discovery window
devices use the 6107 port number.
Format: LightwareDeviceController -i <IP_address>:<port>
Example: LightwareDeviceController -i 192.168.0.20:6107
Connecting to a Device via a Serial Port
Format: LightwareDeviceController -c <COM_port>:<Baud>
Example: LightwareDeviceController -c COM1:57600
displayed. If no Baud rate is set the application will detect it automatically.
Adjusting the Zoom
default value (100%).
Format: LightwareDeviceController -z <magnifying_value>
Example: LightwareDeviceController -z 1.2
ATTENTION!
To Next Page
Loading...
Need help?
General
