60 Matrix ETERNITY Quick Start
CLIP
CLI detection on TWT Trunks
• By default, all TWT ports are configured to detect ‘DTMF CLI’.
• First find out the CLI type supported by your CO and configure this parameter
accordingly as Rx CLI Type in the ‘TWT Hardware Template’.
CLI presentation on SLT
• By default, ‘DTMF’ is selected as the CLIP Type on all SLT ports in the default
SLT Hardware Template-01 assigned to them.
• The CLIP Type in the template will be set automatically according to the country/
region specific requirements, when you select the ‘Region’.
• First, find out the CLIP protocol supported by the telephone instrument to
connected on SLT Port and configure this parameter accordingly. To change
CLIP type, go to ‘SLT Hardware Template’.
• You may assign different SLT Hardware Templates to different SLT Ports if
required. Go to ‘SLT Parameters’ to assign SLT Hardware Template to SLT
ports.
No configuration is required for CLI detection on Mobile, T1E1, BRI and SIP Trunks.
No configuration is required for presenting the CLI on DKP and ISDN Terminals, SIP Extensions.
Class of Service
• Class of Service is part of the Station Basic Feature Template. By default all the
stations are assigned Station Basic Feature Template-01, in which COS group
01 is assigned for working hours, break hours and non-working hours.
• Go to ‘Class of Service’ page to check the default settings of the CoS group 01
and customize CoS1 group as required.
• To change the CoS group assigned to the station; go to ‘Station Basic Feature
Template’.
To Next Page
Loading...
Need help?
General
