Matrix ETERNITY Quick Start 73
Door Phone Card
• The Door Phone Card in ETERNITY PE is used for operating gadgets and door
phones.
• If you have connected a Door Phone to the door phone port, go to ‘Door Phone’
to program the door phone related parameters.
• If you have connected a relay-based device like a Door Lock, a hooter or a
siren, or any other automated control application, first go to ‘DOP’ under
System Parameters and program the port.
• Similarly, go to ‘DIP’ under System Parameters to program the Digital Input Port,
if you have connected any sensor device.
• If you have connected any gadget that you want to operate remotely, using a
command, or a timetable, or based on a timer, go to ‘Automated Control
Applications’ to program the relevant parameters.
• Please read the topics Digital Output Port, Digital Input Port, Door Phone and
Automated Control Applications in the System Manual before configuring the
Door Phone Card.
• To exit the SE programming mode in Jeeves, click ‘Logout’ button at bottom of
the browser window.
VMS Card
• The ETERNITY automatically assigns un-used SLT software ports (SLT ports
which are not assigned any hardware slot-port) as VMS port.
• The SLT software ports used by VMS card automatically get configured in
Routing Group number 96.
• The ETERNITY automatically assigns Routing Group number 96 as VMS
Group.
• Default access code of the VMS group is 3931, You may change this access
code on the ‘Access Codes’ page of Jeeves.
• To land incoming calls on VMS, program Routing Group 96 as Trunk Landing
Group (TLG) in the trunk feature template assigned to the respective trunks.
To Next Page
Loading...
Need help?
General
