Matrix ETERNITY Quick Start 65
E1 PRI Signaling
• Find out the PRI switch variant supported by the exchange.
• In case of private networking set the ISDN switch variant supported by both the
PBXs.
• By default, the PRI Switch variant is ‘ETSI NET5’.
• Go to ‘PRI/Q-Signaling’, to change the attributes of the PRI signaling.
E1 CAS Signaling
• To set E1 CAS signaling on T1E1 port, go to ‘Port Parameters’ - ‘Signal Type’,
configure it as ‘E1 CAS’.
• By default the E1 Line Signaling Variant is ‘ITU T Q.400 – Q.490’ and E1
Registered Signaling variant is ‘MFC R2’.
• If your ETERNITY is connected to the public network, find out the Line Signaling
and Registered Signaling variant supported by the exchange. If you have
installed the ETERNITY in a private network, use the signaling variant
supported by both PBXs.
• Go to ‘E1 CAS Signaling’ to change the attributes of the E1 CAS signaling.
T1 RBS Signaling
• To set T1 RBS signaling on T1E1 port, go to ‘Port Parameters’ - ‘Signal Type’,
configure it as ‘T1 RBS’.
• By default, the T1 Line Signaling Variant is ‘E&M Wink Start FGD’ and
Registered Signaling variant is ‘DTMF’.
• Ask your exchange about the T1 Line Signaling and Registered Signaling
variant supported by the exchange, while in case of private networking set the
signaling variant supported by both the PBXs.
• Go to ‘T1 RBS Signaling’, to change the attributes of the T1 RBS signaling.
• EachT1E1 Port is assigned following templates in default configuration:
• Trunk Feature Template Number 01
• Station Basic Feature Template Number 01
• Station Advance Feature Template Number 01
To Next Page
Loading...
Need help?
General
