112
Control systems
COMAND satellite radio
Tuning in channels
You have the following selection options:
앫 The channel search function
앫 The channel presets
앫 The manual channel number entry
앫 The channel list
Tuning in channels using channel
search function
왘 Slide omp or rotate ymz when the
main area is selected.
Depending on the direction in which
the controller is being pressed or rotat-
ed, the system searches upward or
downward and stops at the next receiv-
able channel.
Tuning in channels using channel
presets
왘 Select “Audio” “Audio” “Sat Ra-
dio” “Presets”.
or
왘 Press n when the main area is select-
ed.
The preset menu appears. The dot R
in front of a preset position indicates
that this is the channel currently select-
ed and being listened to.
왘 Select station preset and briefly
press n.
or
왘 Enter a position number with the tele-
phone keypad using the A - 9
buttons (
컄 page 90).
COMAND tunes in the corresponding
channel as long as it is included in your
subscription and is still available.
If the channel is not included in your sub-
scription, you will see the message de-
scribed in the section “Satellite radio
service is not activated” (
컄 page 110).
i
This function is not possible when only the
preview channel is activated. If you try to tune in
a channel in this instance, you will see the
screen described in the section “Satellite radio
service is not activated” (
컄 page 110).
i
Which channels are found by the channel
search function depends on which channels you
have subscribed to and the program category
you have selected (
컄 page 111).
To Next Page
Loading...
Need help?
General
