312
Control systems
Voice Control introduction
Setting volume level
왘 Activate Voice Control.
왘 Speak a command, for example “Help”.
왘 Press æ or ç. The volume is in-
creased or decreased during voice out-
put.
or
왘 Set volume for voice output using the
COMAND volume thumbwheel on the
lower part of the front center console
(
컄 page 98).
Displays
COMAND Display
In addition to the acoustic help function,
a visual help function (
컄 page 261) is avail-
able on the COMAND display.
Upon activating the Voice Control, the
most important available commands for
the currently active system appear on the
COMAND display.
When the Voice Control System requires
additional information from the user, a se-
lection list is shown on the COMAND dis-
play in the address book and navigation
system.
1 COMAND display
Multifunction display
For example: telephone numbers are
shown on the multifunction display while
dialing when the main “Telephone” menu
is selected in the instrument cluster con-
trol system.
1 Multifunction display
Symbols
The following symbols are found in follow-
ing Voice Control System pages:
s This symbol stands for commands
and voice entries you are speaking.
t This symbol stands for voice output
by the system.
u This symbol indicates that informa-
tion is available on the COMAND
display.
To Next Page
Loading...
Need help?
General
