230
Control systems
COMAND navigation system (Point of interest entry)
왘 Selecting another state (USA) or
province (CDN): Select the first list
entry.
A list of states/provinces appears.
왘 Select desired state (USA) or province
(CDN).
If there are no POIs for the selected
state (USA) or province (CDN), you will
see a corresponding message.
왘 Closing message: Select “OK”.
You can again select a state (prov-
ince).
If there are POIs, you will see the cate-
gory list again.
왘 Proceed as described in the “Selecting
a category” paragraph in the “Main cat-
egory list without input characters”
section (
컄 page 232).
Designating a POI category
The categories and POIs available depend
on the distance from the vehicle position
you have set for the POI.
앫 POI in the surrounding area:
categories sorted alphabetically and
POIs sorted by distance within a radius
of about 12 mi around the vehicle posi-
tion are available. You can extend the
search radius using the list options
(
컄 page 235).
앫 POI within a given city:
If you have only entered the state (USA)
or province (CDN) and the city, alpha-
betically sorted categories and alpha-
betically sorted POIs within the city are
available.
If you have entered more than the state
(USA) or province (CDN) and the city,
alphabetically sorted categories and
POIs sorted by distance within a radius
of about 12 mi around the address en-
tered are available. You can extend the
search radius and the category selec-
tion using the list options
(
컄 page 235).
앫 POIs in a different region:
Alphabetically sorted categories and
alphabetically sorted POIs are avail-
able.
Entering a category
Depending on the number of available cat-
egories, the main category list appears for
category entry either with or without input
characters (
컄 page 232).
컄컄
To Next Page
Loading...
Need help?
General
