283
Control systems
COMAND seats
Exiting menu
There are several ways to exit the multi-
contour seat menu.
왘 Press O again.
or
왘 Press any shortcut button.
or
왘 Select another main function from the
main menu line.
Lumbar support
To support the spine, you can adjust the
curvature of the front seat backrests.
왘 Press O.
The main area of the COMAND display
is active. A scale appears.
1 Scale
2 Cursor
3 Current seat
4 Current setting
왘 Select seat (컄 page 282).
왘 Adjusting lumbar support:
Slide omp or rotate ymz until desired
setting is reached.
왘 Confirming selection: Press n.
왘 Switching to the bottom menu line:
Slide omp.
왘 Confirming selection: Press n.
Multicontour seats*, front
To support the spine, you can individually
adjust the backrest contour of the front
seats by regulating the air pressure in the
air chambers of the multicontour seat.
The settings are made on the COMAND
display.
You can adjust the following air chambers:
앫 sides of seat cushion
앫 sides of backrest
앫 backrest curvature in lumbar area
앫 backrest curvature in shoulder area
i
After you have pressed O, the seat last
adjusted is active.
i
If PRE-SAFE
®
has been activated, the air
pressure in the air chambers (on the sides of the
seat cushion and backrest) of the front multicon-
tour seats is increased.
i
When you adjust the multicontour seat,
noises may result from pumping air into or re-
leasing air out of the air chambers.
To Next Page
Loading...
Need help?
General
