155
Control systems
COMAND telephone*
왘 Deleting entire number:
Select ) and press n until the
number is deleted.
왘 Connecting a call (speed-dial pre-
sets 1 -99): Select “S”.
or
왘 Connecting a call (speed-dial pre-
sets 100 - 999): Select “#” after the
digits “S”.
In both cases, the telephone connects
the call to the saved telephone num-
ber. If the speed-dial memory contains
no telephone numbers, you will see a
corresponding message.
왘 Deleting message: Press n.
Calling up speed-dial numbers using the
telephone keypad
왘 Switching screen to telephone
mode: Call up main telephone menu
(
컄 page 149).
왘 Single-digit numbers: Press and hold
the A - 9 buttons.
or
왘 Single- and two-digit numbers: Enter
number using the A - 9 buttons.
왘 Press s.
or
왘 Three-digit numbers: Enter number
using the A - 9 buttons.
왘 Press #, and then s.
In all three cases, COMAND connects
the call to the saved telephone num-
ber. If the speed-dial memory contains
no telephone numbers, you will see a
corresponding message.
왘 Deleting message: Press n.
Functions during a single-call
connection
Illustration: telephone mode during a call
1 Symbol for active telephone con-
nection (also visible in other operating
modes)
2 Signal strength display
3 To switch hands-free microphone on or
off
4 Length of call display
5 To send character strings
6 To end a call
7 Person you are calling
To Next Page
Loading...
Need help?
General
