521
Controls in detail
Panorama roof with power tilt/sliding panel*
왔 Panorama roof with power tilt/sliding panel*
Roller sunblinds
The roller sunblinds are designed to pro-
tect you from excessive sunlight streaming
in through the panorama roof with power
tilt/sliding panel.
The front roller sunblind only operates with
the tilt/sliding panel closed. The front and
rear roller sunblind cannot be operated in-
dividually.
왘 Switch on the ignition (컄 page 370).
Operating front roller sunblind
Roof panel switch
1 Extend front roller sunblind
2 Retract front roller sunblind
왘 Extending or retracting: Move the
roof panel switch to the resistance
point in the required direction of
arrow 1 or 2 until the front roller
sunblind has reached the desired posi-
tion.
왘 Express-extending: Move the roof
panel switch past the resistance point
in direction of arrow 1 and release.
The front roller sunblind extends com-
pletely.
왘 Stopping during Express-extending:
Move the roof panel switch in any di-
rection.
Operating rear roller sunblind from
front
1 Extending and retracting
왘 Extending or retracting: Press
button 1 until the rear roller sunblind
has reached the desired position.
Warning! G
When extending/retracting the roller sun-
blinds, make sure that no one is in danger of
being injured by the closing procedure. The
extending/retracting of the roller sunblinds
can be immediately halted by releasing the
switch or, if the switch was pressed past the
resistance point and released, by pressing
the switch in any direction.
i
To change directions, you must first extend
or retract the rear roller sunblind completely.
To Next Page
Loading...
Need help?
General
