524
Controls in detail
Panorama roof with power tilt/sliding panel*
Synchronizing
The tilt/sliding panel and front roller sun-
blinds must be synchronized
앫 after a malfunction
앫 if the panorama roof with power
tilt/sliding panel can only be opened
with a jerking motion
Tilt/sliding panel and front roller
sunblind
왘 Switch on the ignition (컄 page 370).
왘 Move and hold the roof panel switch in
direction of arrow 2 until the front
roller sunblind is fully retracted.
왘 Keep holding the roof panel switch in
direction of arrow 2 for approximately
1 second.
왘 Move and hold the roof panel switch in
direction of arrow 1 until the front
roller sunblind is fully extended.
왘 Move and hold the roof panel switch in
direction of arrow 1 until the tilt/slid-
ing panel is slightly opened.
왘 Move and hold the roof panel switch in
direction of arrow 2 until the tilt/slid-
ing panel is fully closed.
왘 Keep holding the roof panel switch in
direction of arrow 2 for approximately
1 second.
왘 Check the Express-open feature of the
tilt/sliding panel (
컄 page 523).
If the tilt/sliding panel opens com-
pletely, the roof is synchronized. Other-
wise repeat the above steps.
Rear roller sunblind
왘 Switch on the ignition (컄 page 370).
왘 Press button 1 until the rear roller
sunblind is fully retracted.
왘 Keep holding button 1 for approxi-
mately 1 second.
To Next Page
Loading...
Need help?
General
