253
Control systems
COMAND navigation system (destination memory)
Deleting a destination from the destina-
tion memory
왘 Select “Navi” “Destination”
“From Memory”.
Depending on the number of entries in
the destination memory, you will see
the destination memory list with or
without input characters.
Example illustration: destination memory
list without input characters
Example illustration: destination memory
list with input characters
1 Input characters
왘 Select desired destination. Proceed as
described for destination entry in the
“Entering a destination from the desti-
nation memory” section (
컄 page 223).
왘 Select “Delete” after selecting the des-
tination to be deleted.
A prompt appears asking whether you
want to delete the destination.
왘 Select “Yes” or “No”.
If you select “Yes”, COMAND deletes
the destination.
i
If the navigable address data of the destina-
tion to be deleted has also been assigned to an
address book entry, COMAND deletes the data
there as well. If the corresponding address book
entry does not contain any further data, such as
telephone numbers, COMAND deletes the entire
address book entry.
To Next Page
Loading...
Need help?
General
