Motorola MC68HC908AB32 User Manual

Clock Generator Module (CGM)
Functional Description
MC68HC908AB32 — Rev. 1.0 Technical Data
MOTOROLA Clock Generator Module (CGM) 135
9.4.2 Phase-Locked Loop (PLL) Circuit
The PLL is a frequency generator that can operate in either acquisition
mode or tracking mode, depending on the accuracy of the output
frequency. The PLL can change between acquisition and tracking
modes either automatically or manually.
9.4.2.1 PLL Circuits
The PLL consists of the following circuits:
• Voltage-controlled oscillator (VCO)
• Modulo VCO frequency divider
• Phase detector
• Loop filter
• Lock detector
The operating range of the VCO is programmable for a wide range of
frequencies and for maximum immunity to external noise, including
supply and CGMXFC noise. The VCO frequency is bound to a range
from roughly one-half to twice the center-of-range frequency, f
VRS
.
Modulating the voltage on the CGMXFC pin changes the frequency
within this range. By design, f
VRS
is equal to the nominal center-of-range
frequency, f
NOM
, (4.9152MHz) times a linear factor L, or (L)f
NOM
.
CGMRCLK is the PLL reference clock, a buffered version of CGMXCLK.
CGMRCLK runs at a frequency f
RCLK
, and is fed to the PLL through a
buffer. The buffer output is the final reference clock, CGMRDV, running
at a frequency f
RDV
= f
RCLK
.
The VCO’s output clock, CGMVCLK, running at a frequency f
VCLK
, is fed
back through a programmable modulo divider. The modulo divider
reduces the VCO clock by a factor N. The divider’s output is the VCO
feedback clock, CGMVDV, running at a frequency f
VDV
= f
VCLK
/N. (See
9.4.2.4 Programming the PLL for more information).
The phase detector then compares the VCO feedback clock, CGMVDV,
with the final reference clock, CGMRDV. A correction pulse is generated
based on the phase difference between the two signals. The loop filter

Motorola MC68HC908AB32 Specifications

General

Brand	Motorola
Model	MC68HC908AB32
Category	Controller
Language	English