COCKPIT SX
Page 18
12.1.4. Complete transmitter reset
Menu: (
SETUP, TRANSM) RESET
In this menu you can reset the transmitter to the state
in which it was delivered. This means:
• Model memory 1 contains a model of the EASY type.
• Data in model memories 2 to 12 is erased.
• The owner’s name is reset to “------”.
• The menu text language is set to “EN” (English).
Moving to the RESET menu:
4 to MENU r (SETUP appears)
r (MODEL appears) 3 to TRANSM
r (BAT AL appears) 3 to RESET
Press the 3-D digi-adjustor briefly r to open the menu
(the “0” flashes). You must now set the number 12
using the 3-D digi-adjustor.
The transmitter RESET is only carried out if you
switch it off while the number “12” is flashing.
We selected this procedure in order to exclude the
possibility of carrying out a total RESET accidentally.
The number 12 was deliberately chosen as the key
number, and it can easily be remembered because the
C
OCKPIT SX has twelve model memories.
12.1.5. Version information
Menu:
(SETUP, TRANSM) -VER-
This menu displays the version of the software installed
in your transmitter.
Moving to the -VER- menu:
4 to MENU r (SETUP appears)
r (MODEL appears) 3 to TRANSM
r (BAT AL appears) 3 to -VER-
in the -VER- menu in the INFO 6 display.
In the INFO 6 display you will find the Version No.
below the owner’s name.
12.2. The INFO displays
The following table shows the seven INFO displays and
what they show.
You can “leaf through” the INFO displays by turning the
3-D digi-adjustor (3 4).
INFO 1 Model type symbols
Memory number
Model name
Battery voltage
INFO 2 Model type symbols
Memory number
Timer 1
Battery voltage
ª resets Timer 1 *
INFO 3 Model type symbols
Memory number
Timer 1
Timer 2
ª resets Timers 1 and
2 *
INFO 4 Model type symbols
Memory number
Timer 2
ª resets Timer 2 *
INFO 5 Model type symbols
Memory number
Transmitter operating time
INFO 6 Model type symbols
Memory number
Owner’s name
Software version
INFO 7 Model type symbols
Memory number
Transmission frequency
Channel
* In INFO displays 2 to 4 you can reset the various
timers with a long press ª on the 3-D digi-adjustor.