Multiplex COCKPIT SX User Manual

Operating Instructions
Page 3
ENGLIS
H
15.7.3. V-tail compensation inputs
Menus: TH -CO, SP -CO 54
15.8. Transmitter control settings
Dual-Rate and Exponential
for AILERON, ELEVATOR and RUDDER........54
15.8.1. Dual-Rate for AILERON, ELEVATOR, RUDDER
Menu: (
CONTRL) DR 54
15.8.2. Setting the Exponential function
Menu: (
CONTRL) EXP 54
15.9. Activating flight phases.....................................55
15.9.1. What is possible with flight phases? 55
15.9.2. Activating flight phases
Menu: (
SETUP, MODEL) PHASES 55
15.9.3. On-screen display of the active flight phase 56
15.9.4. Copying flight phases
Menu: (
PHASENS) COPY 56
15.9.5. Setting the transition speed for switching flight phases
Menu: (
PHASES) SPEED 56
15.10.Further possible functions
with the ACRO model type ...............................57
15.10.1. Combi-Switch 57
15.10.2. Push-button fixed values (automatic aerobatics)
Menu: (
CONTRL) FIX 57
15.10.3. Deltas and flying wings
Menu: DELTA 58
15.10.4. Electronic Y-lead
Menu: (
MIXER) Y-LEAD 58
16. Setting up a new model
Model type: HELI 59
16.1. What is possible with the HELI type? ...............59
16.1.1. Important information on flight phases! 59
16.1.2. Notes on the terms ROLL, PITCH-AXIS and YAW,
as used in the menus 59
16.2. Preparing the model .........................................59
16.2.1. Determining the rotor head type 59
16.2.2. Connecting the servos to the receiver 60
16.3. Preparing the transmitter ..................................60
16.3.1. Setting up a new memory for the HELI type
Menu: (
MEMO) NEW 60
16.3.2. Setting the stick mode
(which stick controls which function?)
Menu: (
SETUP, MODEL) MODE 61
16.3.3. Transmitter controls for the HELI type 61
16.3.4. Setting the rotor head type
Menu: (
MIXER, ROTOR) TYPE 61
16.3.5. Selecting the stick position for throttle idle / collective
pitch minimum
Menu: TH R (Reverse) 62
16.3.6. Throttle trim and the collective pitch stick 62
16.3.7. Selecting the right-hand slider minimum setting forward
/ back (Throttle Limiter and Direct Throttle)
Menu: (
SETUP, MODEL) SP+L R 62
16.3.8. Setting up Throttle Check Warning: “TH >0” 63
16.4. Setting up the swashplate servos.....................63
16.4.1. Checking and correcting the direction of rotation
of the swashplate servos for COLLECTIVE PITCH 63
16.4.2. Checking the direction of rotation
of the swashplate servos for ROLL and PITCH 63
16.4.3. Setting up the swashplate for rotor head types 1 to 4 64
16.5. Setting the collective pitch curve
Menu: (
CONTRL) PITCH.................................64
16.6. Everything about throttle...................................65
16.6.1. The meaning of Limiter, Curve, Minimum, Trim, DTC
and Throttle Cut 65
16.6.2. Setting up the throttle servo for a glow motor 65
16.6.3. Throttle for electric helicopters 66
16.6.4. Setting up the throttle curve
Menu: (
CONTRL) TH 66
16.6.5. Setting throttle minimum (idle)
Menu: (
CONTRL) TH MIN 66
16.6.6. Setting throttle for auto-rotation
Menu: (
CONTRL) TH AR 67
16.7. Setting up the tail rotor
Menu: TAIL.....................................................67
16.7.1. Checking / correcting the direction of rotation, centre
and maximum travel of the tail rotor 67
16.7.2. Setting the YAW input for the tail rotor 68
16.7.3. Zero point for tail rotor mixers
Menu: (
MIXER, TAIL) CP ZRO 68
16.7.4. Setting the CP input for the tail rotor (REVO-Mix) 68
16.7.5. Setting an OFFSET for the tail rotor 69
16.8. The helicopter gyro
Menu: (
MIXER) GYRO .......................................69
16.8.1. Setting gyro gain 69
16.8.2. Activating HEADING mode
Menu: (
CONTRL, GYRO) HEADG 69
16.8.3. Checking the heading function 70
16.9. Transmitter control settings
Dual Rate and Exponential
for ROLL, PITCH-AXIS and YAW.....................70
16.9.1. Setting Dual Rate for roll, pitch-axis and yaw
Menu: (
CONTRL) DR 70
16.9.2. Adjusting the Exponential function
Menu: (
CONTRL) EXP 70
16.10.Activating flight phases .....................................71
16.10.1. What is possible with flight phases? 71
16.10.2. Activating flight phases
Menu: PHASES 71
16.10.3. On-screen display of the active flight phase 71
16.10.4. Copying flight phases
Menu: (
PHASES ) COPY 72
16.10.5. Setting the transition speed for switching flight phases
Menu: (
PHASES) SPEED 72
16.11.Virtual swashplate rotation
Menu:
(MIXER ROTOR) V-ROT .......................72
17. The free mixers MIX 1, 2 and 3 73
17.1. Defining / adjusting the free mixers
Menu: (
MIXER) MIXDEF..................................73
17.2. Adjusting the mixer effect .................................73
17.3. Erasing the free mixers.....................................74
18. Managing model memories
Menu: MEMO 74
18.1. Switching the model memory
Menu: (
MEMO) GO TO ......................................74
18.2. Setting up a new model
Menu: (
MEMO) NEW............................................75
18.3. Entering / changing the model name
Menu: (
MEMO) NAME .........................................75
18.4. Copying model memories
Menu: (
MEMO) COPY .........................................75
18.5. Erasing model memories
Menu: (
MEMO) DELETE ....................................76
19. Timers 1 and 2, operating time 76
19.1. Timer 1..............................................................76
19.1.1. Assigning a switch
Menu: (TIMER) T1 SW 76
19.1.2. Operating Timer 1 with an alarm
Menu: (
TIMER) START1 76

Multiplex COCKPIT SX Specifications

General

Brand	Multiplex
Model	COCKPIT SX
Category	Remote Control
Language	English