Optional Accessories
E-13
Part 1128350_02
E 2020 Nordson Corporation
Fulfill System Specifications
The following specifications are specific to the Fulfill integrated fill system.
For general ProBlue melter specifications, refer to the melter manual.
Parameter Specification
Melter operating temperature range 40-205 _C (104-400 _F)
Adhesive forms
Maximum size
Pellets, pastilles, mini-slats
S Pastilles: 12 mm (0.472 in.) diameter
S Mini-slats: 12 mm X 12 mm (0.472 in. X 0.472 in.) in length
Input voltage 100-240/1 VAC, 1 A
Adhesive transfer maximum rate 275 kg (600 lb)/hour (dependent on adhesive type and air
pressure)
Transfer hose length 4m(13ft),9m(29.5ft),or18m(59ft)
Operating air Minimum: 4.5 bar (0.45 MPa or 65 psi)
Maximum: 8.6 bar (0.86 MPa or 125 psi)
Air line tubing size (between
solenoid valve and suction lance)
10-mm OD, 8-mm ID
Total air consumption
S 17 CFM @ 50 psi to transfer 105.3 kg/hr (223.2 lb/hr) with 4m
hose @ 4m rise
S 22 CFM @ 60 psi to transfer 112.5 kg (248 lb/hr) with 9m hose
@4mrise
S 30 CFM @ 90 psi to transfer 90.7 kg/hr (200 lb/hr) with 18m
hose @ 4m rise
NOTE: The sequencer ensures that only one melter is filled with
adhesive when multiple melters generate a low level signal at the
same time.
Conditioning Dry, non-lubricated
Inlet air connection ¼-in. NPT f emale
¼-in. BSPP female
G ¼ female
Pump type Venturi
Noise emission 76 dBA
Suction lance dimensions
(optional)
(L) 615 mm x (W) 105 mm maximum
(24.21 in. x 4.14 in. maximum)
Adhesive storage bin capacity 120L(264lb)or240L(528lb)
Enclosure rating IP54
Single-feed bin adhesive container
capacity
40 kg (88 lb) usable with grate; 64 kg (141 lb) usable without
grate
Multi-feed bin adhesive container
capacity
110 kg ( 242 lb) usable with grate; 128 kg (282 lb) usable without
grate
To Next Page
Loading...
Need help?
General
