Installation
3-35
Part 1128350_02
E 2020 Nordson Corporation
Set Up the Melter
After physically installing the melter, it must be set up to support your
manufacturing process. Melter setup consists of enabling or making changes
to factory-set operating parameters that affect the use and function of the
melter. The operating temperature (set point) of the tank and each hose and
applicator is also established during melter setup.
The melter is shipped from the factory with the most commonly used
operating parameters already set up. The factory setup can be modified at
any time to suit your manufacturing process.
Using the OLED User Interface
Use the components on the melter's OLED user interface to navigate the
different menus for setting up, operating, and fine-tuning the system settings.
Refer to the accompanying Quick Reference Guide (P/N 1128354) for an
overview of the OLED user interface and the menu structure.
Refer to the ProBlue Flex Adhesive Melter Using the OLED User Interface
Manual (P/N 1128351) for detailed and advanced instructions on setting up
themenusforoperation.
To Next Page
Loading...
Need help?
General
