Basic Melter Operation
4-1
Part 1128350_02
E 2020 Nordson Corporation
Section 4
Basic Melter Operation
WARNING! Allow only personnel with a ppropriate training and experience to
operate or service the equipment. The use of untrained or inexperienced
personnel to operate or service the equipment can result in injury, including
death, to themselves and others, and damage to the equipment.
Operator Level Tasks
The following is a list for accomplishing operator-level tasks:
1. Filling the melter tank.
2. Starting the melter.
3. Operating the melte r.
4. Shutting the melter down.
Before proceeding with the next set of tasks make sure the melter is fully
installed and connected as described in the accompanying Installation Guide
(P/N 1128353).
Additional Information
This section presents operating procedures in their most commonly used
form. Procedural variations or special considerations are explained in the
additional information that follows most procedures.
To Next Page
Need help?
General
