Hose/Applicator Expansion Base
G-12
Part 1128350_02
E 2020 Nordson Corporation
Using Melter with Expansion Base in a Water Wash Environment
Perform the following step in instances when the melter with the expansion
base may be sprayed with water from the bottom:
Prior to mounting the expansion base on to the sub-base, place the water
wash stickers over the internal screw holes that do not have mounting
screws installed.
NOTE: Each sub-base includes a set of two stickers (P/N 1129206) for
use in a water wash environment.
Figure G-9 Placing stickers on the s ub-base
For instructions on mounting the expansion base on to the sub-base refer to
Mounting the Expansion Base to the Sub-Base givenearlierinthisappendix.
To Next Page
Loading...
Need help?
General
