10
Safety information
Repair
Repair of the product must only be performed by trained qualied servicing personnel that
has been authorized by Olympus. Otherwise, Olympus cannot be held responsible for the
safety and performance of the product.
Be aware that also fuses must only be changed by an authorized service center.
Installation and setup
The electrosurgical generator and its peripheral equipment must be properly installed and
set up by qualied personnel that has been authorized by Olympus.
Regular safety check
The regular safety check must only be performed by a qualied electrician with sufcient
experience in maintaining medical electrical devices.
The regular safety check must only be performed in a technical laboratory with appropriate
equipment.
Software update
Software updates must only be performed by qualied personnel.
2.1.5 Clinical benets
Clinical benets depend on the applied part used with the device.
2.2 Contact
2.2.1 Manufacturer
Olympus Winter & Ibe GmbH
Kuehnstr. 61
22045 Hamburg
Germany
Country-specic information
Refer to the contact information for customers included in the scope of delivery for country-
specic information.
2.2.2 Incident reporting
If a serious incident occurs with the device, report it to the manufacturer and/or the relevant
national authority according to national legislation.
2.3 General safety notes
The following safety information address points that apply to the general handling and use of
the product. This information is to be supplemented by the information given in each chapter
of this document.
Read all instructions for use thoroughly
Before use, read this instructions for use and the instructions for use for all other equipment
which will be used during the procedure.
To Next Page
Loading...
Need help?
General
